Gastroback Design Mincer Provozní pokyny stáhnout pdf (Strana 7)

2. Loosen the screw plug on the left side of the mincer tur ning it

anticlockwise. Firmly secure the worm housing in the opening for

the drive shaft. The opening of the wor m housing should be

upright.

Hold the worm housing with one hand and insert the screw plug

into the side hole of the motor block. T urn the screw clockwise

(see. fig. 1) for tightening. Do not use force and be careful to not

overwind the screw thread.

WARNING: The blades of the crossed-blade knife are ver y

sharp. Pay attention when you handle the crossed-blade knife.

3. Insert the wor m with the longer , narrower end into the w orm

housing and turn slightly until it is securely seated in the wor m housing

(see fig. 2). The sealing ring and then the grommet should be

placed at the narrow end of the wor m. Make sure that the wor m is

placed completely in the inside of the worm housing. If necessary turn

the worm a little bit to make it fit.

WARNING: Never use the crossed-blade knife and the mincer

plate together with the chopper attachment. How to work with the

chopper attachment is explained within the recipe.

4. Mount the knife on the wor m in the illustrated manner: The

rounded side of the knife must face the wor m, the smooth side is i n

contact with the mincer plate (see fig. 3). Meat will not be minced

if the knife is mounted the wrong way round.

IMPORTANT: If the tools overlap the edges of the worm housing

the worm is not placed all the way inside of the wor m housing.

Turn the worm a little bit to make it fit inside but do not use force.

5. Mount the mincer plate on the knife. The two arresting pins

must lock precisely into the corresponding recesses (see fig. 4).

6. Firmly screw on the closing ring. Do not over -tighten (see fig. 5).

WARNING: Do not use any tools, for tightening the screw and p ay

attention not to cant the screw . If the screw cants the screw thread

gets damaged. If the screw does not turn easily put some sunflower oil

(or other edible oil) on the screw.

7. Press the feed pan firmly onto the mincer.

8. Place the mincer on a fir m base.

The mincer is now ready for operation.

41400_Manual_Fleischwolf_Juli2009.qxp 19.11.2009 09:23 Seite 24

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Žádné komentáře

Gastroback Design Mincer Provozní pokyny Strana 7